CCNA Notes : cont..
57. Show IP protocol: This command will show information on RIP
timers including routing update timer (30sec default), hold-down
timer (default 180sec). It also displays the number of seconds due
for next update (this is fraction of update timer). This command
also gives the network number for which IP RIP is enabled, Gateway,
and the default metric.
1.
Show IP route: This command will display the IP routing table
entries. In addition, it displays the Gateway of last resort (if one
is assigned). It also displays the codes used for various types of
routes. Some of the important codes are:
C:
directly connected;
S:
Statically connected
I : IGRP
R
: RIP
2.
Show IP interface: This command shows you interface-wise
information such as IP address assigned to each interface, whether
the interface is up, MTU etc.
3.
Debug IP RIP: Debug IP RIP will turn the RIP debugging ON. This will
display a continuous list of routing updates as they are sent and
received. This leads to lot of overhead, which is the reason that
you use "undebug ip rip" to turn-off debugging as soon as you finish
with debugging.
|